:Templates/5/en

Apart from selectors that use absolute, predefined time slots there are also selectors that look for a certain amount of time into the past.

• val1, val1, val3, ..., val60: selects the value the sensor has shown one to 60 minutes ago (This is only available for sensors with ID 0 and 1, like "th0temp" or "th1temp", unless you have a Meteobridge PRO).
• max1, max2, max3, ..., max60: selects the maximum value from the last one to 60 minutes
• min1, min2, min3, ..., min60: selects the minimum value from the last one to 60 minutes
• avg1, avg2, avg3, ..., avg60: selects average value from the last one to 60 minutes

For sensors delivering cumulated values like "rain0total" and "sol0evo" the following selectors are defined:

• sum1, sum2, sum3, ..., sum60, sum1h, sum2h, sum3h, ..., sum24h: selects summarized delta values from the last one to 60 minutes or one to 24 hours. This is useful to get amount of total rain in a certain time frame: "rain0total-sum60" is rainfall in mm of last 60 minutes.
• delta1, delta2, delta3, ..., delta60, delta1h, delta2h, delta3h, ..., delta24h: selects difference between current value and value from one to 60 minutes or one to 24 hours ago. A positive number shows that value has increased, a negative number indicates the value has decreased. This is useful to do trend analysis over various time spans.